|
|
Floor Candle Holder |
|
Home
About the Artist Portfolio Store Commissions
Media Accolades
Awards
Contact
|
|
|
| The center piece of this candle is two inches wide by a quarter inch thick, it is drawn down at both ends and has an elegant twist in the center. Both the candle plate and the base are a quarter inch thick plate that has been drawn out on the edges cause a rippling effect. Even though this candle holder was made in my third year of blacksmithing (1997), I still think it has nice lines and am proud of it. It stands 36" tall. |
|
Portfolio: |
|
Railings, Gates, Grilles & Fences l Reproductions & Restoration Hardware l Locks & Hardware I Candle Holders I Other Neat Stuff |
|
Floor Candle Holder I Joinery Candle Holder I Torchiere I Block Candle Holder |
|
Home l
About the Artist l Portfolio
l Store l Commissions
l Media Accolades l Awards
l
Contact
|
|
Tudor Ironworks
|
|
|
Nigel Tudor, Metalsmith 1061 Sugar Run Road Avella, Pennsylvania 15312 |
|
|
email
questions or comments 724.587.3763 |
|
|
|
